Tech Tips
xControl: Flexible External Control Expansion
VoIP Digit Map
TECH TIPS The Digit Map (also called the Dial Plan) defines a collection of digit pattern templates that are used…
Using the SymNet Composer Radius 12×8 to Radius EX Migration Feature
TECH TIPS Using the SymNet Composer 3.0 Radius 12x8 to Radius EX Migration Feature With the release of the Radius EX…
Using Symetrix USB Audio Card with For The Record Gold Software
Using Momentary Buttons in SymVue on a Touchscreen PC in Composer
TECH TIPS
Using Dante’s Device Lock Feature with Symetrix Dante-enabled Hardware
The purpose of this Tech Tip is to provide instructions on using Dante’s Device Lock feature with Symetrix Dante-enabled hardware…
USB Audio Card Symetrix Driver Windows 1×1 Mode Fix
TECH TIPS
Updating Firmware with Composer
The purpose of this document is to provide information and set by step instructions for the proper firmware upgrade process.…
Understanding Class C Subnet Masking
Troubleshooting your Windows PC to Symetrix Hardware Connection
Trace Signal Path UP/DOWN stream in Composer
Tips & Tricks for Successful AEC
Having a general understanding of the AEC module parameters prior to reading this Tech Tip is essential for success during…
Tech Tip: Emergency Paging
https://vimeo.com/840246398?share=copy
SymVue Control Screen Setup and Export
SymVue Control Screens are a powerful and flexible option for system control. This Tech Tip explains how to export a…
Symetrix VoIP Interface – Network Diagnostics
TECH TIPS
String Output Modules in Composer
SPL Computer in Composer
Sound Masking with SymNet Composer
Setup Dante in 5 Minutes Time or Less in Composer
Setting up Symetrix 2 Line VoIP Interface for use with Cisco Unified Communications Manager
Selected Wire Audio and Real-time Monitoring via Host Computer Speakers
The purpose of this Tech Tip is to show you how to probe, listen to, and meter any signal by…
Running Microsoft Windows® on a Mac
Room Combine Logic with Mix-Minus Matrixing of Room Mics
TECH TIPS In a large convention center or conference room, microphones may be routed to different speaker zones in a…
Recommendations for using Yamaha Dante Consoles with Composer
Recommendations for Large Dante Networks
Radius AEC: Cutting Edge, Low Cost AEC with Options
TECH TIPS
Radius AEC Template Guide
Radius-AEC-Template-Guide-4Download
Protocol: Jupiter 4, Jupiter 8, Jupiter 12
The purpose of this document is to provide a technical understanding of the Symetrix Control Protocol for Jupiter. It will…
Optimizing Symetrix software MTU Settings on your PC
New Example Conferencing Site Files in Composer 6.0
Multiple Source Network Receive Module
TECH TIPS
Mono Source Select and Volume Control for Zone Mix 761 using ARC-2e and ARC-WEB remotes.
ARC remotes are a powerful and intuitive form of system control for systems using Symetrix DSPs. This Tech Tip will…
Mono Source Select and Volume Control for Jupiter using ARC-2e and ARC-WEB remotes.
The ARC-2e and ARC-WEB are powerful, flexible tools for controlling the Symetrix Jupiter series DSPs. Set up is quick, but…
Monitoring SymNet Hardware Diagnostics
Modular ARC Installation
Overview The Modular ARCs are a series of two base remotes and one expansion device. The Modular ARCs, as their…
Managing Multicast Dante Flows on a Network using IGMP Snooping in Composer
Making a Latched Button Act like a Momentary Button
Occasionally, third party devices may need a control signal to last longer than a momentary button's "press" to activate, but…
Logic Programming in Composer
TECH TIPS
Launch and Control 3rd Party Applications from Composer
Keeping Time, Eliminating Clock Drift in Composer
Jupiter: Simple yet sophisticated
Jupiter packages powerful DSP into a zero learning curve, turn-key audio processing solution drawing its inspiration from the ‘apps’ paradigm…
Jupiter: Five Lesser Known, Yet Powerful, Features
Jupiter DSp comes packed with many eye-catching features, like a library of nearly 70 apps, set-up wizards, and the ability…
Jupiter v3.0 Software Improved Features
Jupiter Software v2.0: Setting-up ARC-WEB
The Symetrix ARC-WEB is a web app remote control for the Jupiter family of audio processors. Now you can use…
Jupiter Software v.1.2.1.15: Apps and Features
Jupiter Application Selection Guide
Juice Goose Super-Modules
Introducing the Integrator Series Zone Mix 761
Interfacing a Lifesize 220 System with a Symetrix DSP
Integrating Visionary Solutions Duet Encoders/Decoders
TECH TIPS
Integrating the Earthworks IML & IMBL Microphones and the LumiComm Touch Ring with a Symetrix DSP
Integrating the Button Processor Super-Module in Composer
Integrating Logic Output Circuits into your Installation (Radius/Edge, xControl, Jupiter, 761)
TECH TIPS
Integrating Clockaudio TS005 Touch-switch and a Conference Microphone with Symetrix DSP
Overview This Tech Tip will explain how to integrate the Clockaudio TS005 illuminated Halo LED touchpad and a cardioid desktop…
Integrating Clockaudio CH32 Touch-switch and a Conference Microphone with Symetrix DSP
Input Logic Modules in Composer
How to use Stewart Audio end points in Composer:
TECH TIPS
How to use LEDs with Momentary Buttons for System State
Many installations include power sequencers that power down most of the greater system while a Symetrix DSP remains powered for…
How to use LEDs to indicate “active” presets on Control Screens.
In Symetrix DSPs, the word "active" isn't quite the right term to describe presets. Presets are simply a snapshot of…
How to use Attero Tech Dante endpoints in Composer
How to setup Skype with Dante Virtual Soundcard in a SymNet conferencing system
How to setup Microsoft ® Lync with Dante Virtual Soundcard in a SymNet conferencing system
How to Set Up Skype with the Attero Tech unDUSB in a Symetrix conferencing system
How To Set Minimum and Maximum Gain on W Series Remote
Unlike ARC Series remotes, W Series remotes do not have a built-in method for setting upper and lower boundaries for…
How to schedule a configuration reset
TECH TIPS During daily operation end users may have access to volumes, mutes, combine states, presets and routing, and as…
How to record audio from a Dante bus in SymNet Composer to your computer in Composer
How to receive audio in Edge/Radius/Prism from Dante Virtual Soundcard
How to Integrate External Control Inputs on Symetrix DSP Hardware
How to Integrate an ARC-K1e with ARC-EX4e (or ARC-SW4e).
The ARC-K1e is a simple, intuitive ARC remote that can be used for many parameters. However, the large majority of…
How To Find Example Site Files in SymNet Designer and Composer
How to disable Skype’s Echo cancellation and AGC for use with Dante and Symetrix AEC
To disable Skype’s auto gain control (AGC) for Windows versions, go to Tools > Options then select Audio settings. Then…
How to Create SymVue Control Screens with Dimensions Greater than the Design PC Screen Resolution
How to Control the Shure MXA310 in Composer
How to Assign a Static IP Address to the Dante Port in Dante Controller
TECH TIPS
Green Ethernet/IEEE Protocol/Energy-Efficient Ethernet
TECH TIPS
GPIO Overview
Gain Structure: Maximize Dynamic Range, Minimize the Noise Floor in Composer
TECH TIPS
Expanding Jupiter Control Using Custom Modular ARC Programming
TECH TIPS By using SymNet Designer, the entire line of Symetrix Modular ARC panels can be made to control any…
Executing a Windows Shutdown Command from SymVue
Ducker Module: SymNet Designer vs SymNet Composer
DSPs and ARC-PS; adapting CAT5 for RS-485 Terminal Block
Connecting ARCs to Jupiter hardware is simple using the (RJ-45) ARC port on either the front or back of the…
Downgrade Failures Prior to Composer 6.0
Disable xIO in Composer to Minimize Push Time
Dialing the SymNet Analog Telephone Interface with a 3rd Party Control System in Composer
Debounce a Switch Connected to a SymNet Analog Control Input
All SymNet DSP units are equipped with analog control inputs. These inputscan be utilized in various ways to provide control…
Dante: Know It, Use It, Troubleshoot It.
Dante Redundancy
Dante PHY-to-PHY Device Audio Dropouts
Dante Controller Troubleshooting and Logging Instructions
Custom Presets in Jupiter
TECH TIPS
Crestron Symetrix Dialer Example in Composer
Creating Volume Controls in an ARC-2e or ARC-WEB that Display in Percentage
In order to be effective, end user control systems need to be simple and intuitive. Some might even call the…
Creating Telephone Dialers with SymVue
Controlling Symetrix SymNet, Jupiter and Integrator Series Products over the Internet
TECH TIPS
Control Network Considerations
This article contains information and guidelines related to controlling Symetrix and third-party products using IP, Dante, serial, and other technologies.…
Composer v5.2 Shortcuts
Composer Push, Pull, and Sync
Composer docking and panel resizing
Comparing Symetrix Composer Site Files
Combined Analog and Remote Mic Switch Super-module in Composer
CLOCKAUDIO CDT100 in Composer
TECH TIPS
Automix Matrix Apps in Composer
ATI Card: Dialers and Connection
ARC-PSe
TECH TIPS The Symetrix ARC-PSe provides serial control and power distribution over standard CAT5/6 cable for systems with more than…
ARC-3 Dynamic Menus
The ACR-3 wall panel delivers powerful capabilities with Dynamic Menus. Dynamic Menus allow you to enable an entire ARC or…
ARC Network Design and Pinout
An ARC’s current requirements vary depending on the voltage supplied to it. For example, an ARC-2e with a 15 VDC…
AMX VoIP & ATI Modules
Adding Third-Party Dante Devices to the User Library
Adaptive Remote Control: ARC-2e Wiring
The ARC-2e is a menu-driven adaptive remote control for Symetrix DSPs. Featuring a more simplified design for enhanced reliability and…
Adaptive Remote Control: ARC-2e Benefits and Features
The ARC-2e offers modernized and simplified hardware design for greater reliability and a lower cost. The adaptive remote control ARC-2e…
2 Line Analog Telephone Interface Card Creates New Possibilities in Composer
